KTM 450 XCR-W USA User Manual

10/REAR WHEEL 40
400225-10
ಥ Loosen nut.
ಥ Loosen nuts
.
ಥ Adjust the chain tension by turning the left and right adjusting screws
.
Specification
Chain tension 8… 10mm (0.31… 0.39in)
Turn the left and right adjusting screws
 so that the markings on the left and
right chain adjusters are in the same position relative to the reference marks
.
The rear wheel is then correctly aligned.
ಥ Tighten nuts
.
ಥ Make sure that chain adjusters
 are fitted correctly on the adjusting screws.
ಥ Tighten nut
.
Specification
Nut, rear wheel spindle M20x1,5 80Nm
(59.01lbfft)
Info
The wide adjustment range of the chain adjusters (32 mm) enables different
secondary transmissions with the same chain length.
Chain adjusters
 can be turned by 180°.
ಥ Remove the motorcycle from the work stand. ( P. 8)
Adjusting chain guide
400252-10
ಥ Remove screws and. Take off the chain guide.
Conditions
Number of teeth: 싨44teeth
ಥ Insert nut
 in hole. Position the chain guide.
ಥ Mount and tighten screws
 and.
Specification
Remaining screws, chassis M6 10Nm
(7.38lbfft)
Conditions
Number of teeth: 싩45teeth
ಥ Insert nut
 in hole. Position the chain guide.
ಥ Mount and tighten screws
 and.
Specification
Remaining screws, chassis M6 10Nm
(7.38lbfft)
Checking the rear sprocket / engine sprocket for wear
400227-01
ಥ Check the rear sprocket / engine sprocket for wear.
» If the rear sprocket / engine sprocket are worn:
ಥ Replace rear sprocket / engine sprocket.
Info
When fitting the chain joint, always make sure that the closed side
of the joint faces forward (riding direction).
The engine sprocket, rear sprocket and chain should always be re-
placed together.
ಥ Check that the chain guide is firmly seated and not worn.

KTM 450 XCR-W USA Specifications

General

Brand	KTM
Model	450 XCR-W USA
Category	Motorcycle
Language	English