KTM 450 XCR-W USA User Manual

00
0
BB
00AA
CC
00AA
04/SHOCK ABSORBER, SWINGARM 22
Checking static sag of the shock absorber
400221-10
ಥ Measure distance of rear wheel unloaded. ( P. 21)
ಥ Ask someone to help you by holding the motorcycle upright.
ಥ Measure the distance between the rear axle and the fixed point again.
ಥ Make a note of the value as measurement
.
Info
The static sag is the difference between measurements and.
ಥ Check the static sag.
Static sag 35mm (1.38in)
» If the static sag is less or more than the specified value:
ಥ Adjust the spring preload of the shock absorber.
Checking the riding sag of the shock absorber
400222-10
ಥ Measure distance of rear wheel unloaded. ( P. 21)
ಥ With another person holding the motorcycle, sit on the saddle with full protective
clothing in a normal sitting position (feet on footrests) and bounce up and down a
few times until the rear suspension levels out.
ಥ The other person now has to measure the distance between the rear axle and a
fixed point.
ಥ Make a note of the value as measurement
.
Info
The riding sag is the difference between measurements and.
ಥ Check the riding sag.
Riding sag 105mm (4.13in)
» If the riding sag differs from the specified measurement:
ಥ Adjust the riding sag. ( P. 23)
Adjusting spring preload of the shock absorber
Danger
Danger of accidentsಗThe shock absorber is under high pressure.
ಥ The shock absorber is filled with high density nitrogen. Follow the steps in the repair manual when working on the shock
absorber.
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
ಥ Remove shock absorber. ( P. 23)
ಥ After removing the shock absorber, clean it thoroughly.

KTM 450 XCR-W USA Specifications

General

Brand	KTM
Model	450 XCR-W USA
Category	Motorcycle
Language	English