30/ENGINE - WORK ON INDIVIDUAL PARTS 86
200188-10
ಥ Remove the spring retainer and spring.
ಥ Pull the valve downward out of the valve guide, pry off the valve stem seal and re-
move the lower valve spring retainer.
200189-10
ಥ Mark the valve to indicate the installation position.
Info
Place the valve into a box according to the installation position and label the
box.
Replacing the camshaft bearing
200202-10
ಥ Clamp the cylinder head.
Clamping plate (75029050000) ( P. 180)
ಥ Remove the camshaft bearing using the special tool.
Bearing puller (15112017000) ( P. 177)
Push-out drift (75029051000) ( P. 180)
200199-10
ಥ Remove the small camshaft bearing using the special tool.
Bearing puller (15112017000) ( P. 177)
Insert for bearing puller (15112018100) ( P. 177)
200200-10
ಥ Check parts for damage and wear. Replace damaged or worn parts.
ಥ Press the small camshaft bearing all the way in using special tool
.
Push-in drift (75029044020) ( P. 180)
200201-10
ಥ Press the large camshaft bearing all the way in using special tool.
Push-in drift (75029044010) ( P. 179)
To Next Page
Loading...
Need help?
General
