4. Fill
up with new oil through the filling port to the
specified level.
(1) Oil filling port
(2)
Engine oil dipstick
(A) Required oil level range
Engine oil volumes with engine oil filter 8.5 L
10. Replacing the engine oil filter
cartridge
1. Remove the under cover on the bottom of the frame
to drain the spilled engine oil from the engine-oil-
filter-cartridge.
(1) Under cover
2. Replace
the engine-oil-filter-cartridge at the same
time as changing the engine oil.
a. Remove the engine-oil-filter-cartridge with the
filter wrench.
b. Oil the O-ring of the new engine-oil-filter-
cartridge lightly.
c. Then tighten the engine-oil-filter-cartridge by
hand.
d. Fill engine oil to the specified level.
e. Let the engine run for approx. five min. and
make sure that the low-fuel-warning-light does
not light up.
The engine oil level is reduced by the amount of
the filter capacity after the engine is started. It is
necessary to add the engine oil.
f. Then stop the engine and remove the key.
(1) Engine oil filter cartridge
3. Attach the under cover.
IMPORTANT :
• Always
check the engine oil level after having
exchanged the filter.
EVERY 500 SERVICE HOURS
Carry out all 50, 100, and 250 hour servicing at the
same time.
1. Replacing the water separator
filter element
1. Set
the shutoff-valve of the water separator to the
close position.
2. Loosen and remove the cup properly and replace
the filter element.
3. Check the condition of the O-ring and replace if
necessary.
4. Tighten up the cup properly.
MAINTENANCE EVERY 250 SERVICE HOURS
To Next Page
Loading...
Need help?
General
