(1) Working light switch
Night operation
CAUTION
T
o avoid personal injury:
• Visibility is reduced in darkness, therefore, in
the event the working light alone does not
provide sufficient visibility, use additional
stationary artificial lighting. Observe all safety
rules and any special regulations for night
work.
7. Seat switch
The seat switch is used to detect the operator sitting on
the
seat and to signal the hydraulic system that it can
be unlocked.
When the operator sits on the operator's seat, the seat
switch turns on and the hydraulic system can be
unlocked.
8. Inhibit diesel particulate filter
(DPF) regeneration switch
The inhibit-diesel-particulate-filter (DPF)-regeneration-
switch
(hereinafter called inhibit-DPF-regeneration-
switch) disables the auto DPF regeneration cycle.
Activate the inhibit-DPF-regeneration-switch to turn off
the auto DPF regeneration when working around
people, animals, plants, and flammable materials.
Certain work conditions may require the auto DPF
regeneration cycle to be disabled.
1. When pressing the inhibit-DPF-regeneration-switch
once, the automatic mode turns off.
2. When pressing the inhibit-DPF-regeneration-switch
once again, the automatic mode returns from
disable.
(1) Inhibit Switch
9. Float switch
WARNING
T
o avoid personal injury or death:
• Make sure that the bucket is lowered to the
ground before putting the lift arms in the float
position. Putting the lift arms in the float
position while they are off the ground will cause
the bucket and the lift arms to fall and is
extremely dangerous.
• Do not drive the machine forward with the lift
arms in the float position.
Entering the float mode
While
moving down the lift arm by tilting the right-
control-lever forward, press the float switch on the right-
control-lever and release it no later than 1 second.
The float mode then turns on.
While in the float mode, the
mark on the
instrument panel stays on.
Exiting the float mode
While
the machine is in the float mode, perform either
of the following methods.
• Press the float switch on the right-control-lever.
• Move up the lift arm (pulling the right-control-lever
backward).
(1) Float switch
SWITCHES INSTRUMENT PANEL AND SWITCH
To Next Page
Loading...
Need help?
General
