Kubota WSM F2880 User Manual

2-S24
F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
TRANSMISSION
(2) Hydraulic PTO Clutch Assembly
W1016737
1. Remove the ball bearing (1) and remove the 16T-33T gear (3) with the needle bearings (2), (4).
2. Remove the external snap ring (12), and remove PTO brake plate (13), PTO brake disc (5) and thrust collar.
3. Remove the ball bearing (26), and remove the 33T gear (20) with the ball bearings (19), (24).
4. Slide out the hydraulic PTO clutch assembly from the clutch shaft (18).
5. Remove the internal snap ring (17), and remove the pressure plate (16), clutch discs (15) and steel plates (14).
6. Press the collar and remove the external snap ring (11), and remove the piston (8).
CAUTION
• Return spring (9) is under pressure and retained by external snap ring (11). Carefully compress return
spring (9) before trying to remove external snap ring (11), then carefully release pressure after external
snap ring (11) is removed.
(When reassembling)
• Apply transmission fluid to O-ring (23), D-ring (7), seal ring (27) and take care not to damage it.
• Replace O-ring, D-ring and seal ring, if it is defective.
(1) Ball Bearing
(2) Needle Bearing
(3) 16T-33T Gear
(4) Needle Bearing
(5) PTO Brake Disc
(6) Clutch Case
(7) D-ring
(8) Piston
(9) Return Spring
(10) Collar
(11) External Snap Ring
(12) External Snap Ring
(13) PTO Brake Plate
(14) Steel Plate
(15) Clutch Disc
(16) Pressure Plate
(17) Internal Snap Ring
(18) Clutch Shaft
(19) Ball Bearing
(20) 33T Gear
(21) Internal Snap Ring
(22) Thrust Collar
(23) O-ring
(24) Ball Bearing
(25) Thrust Collar
(26) Ball Bearing
(27) Seal Ring
KiSC issued 04, 2006 A

Kubota WSM F2880 Specifications

General

Brand	Kubota
Model	WSM F2880
Category	Lawn Mower
Language	English