G-26
F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
G GENERAL
[5] CHECK POINTS OF EVERY 200 HOURS
Changing Transmission Fluid
CAUTION
• Be sure to stop the engine before checking and changing
the transmission oil.
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid. (See “Cleaning Transmission Oil
Strainer” below)
4. After draining, screw in the three drain plugs and tighten.
5. Fill the transmission fluid from oil inlet (3) up to the upper line on
the dipstick (2).
6. After running the engine for a few minutes, stop it and check the
fluid level again, add the fluid to the prescribed level if it is not
correct.
IMPORTANT■
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
• Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-7.)
• Never work the machine immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevents damage to the transmission.
• Do not mix different brands fluid together.
W1046657
Replacing Transmission Oil Filter Cartridge
1. See page G-20.
W1037242
Cleaning Transmission Oil Strainer
1. Place an oil pan underneath the transmission oil strainer.
2. When changing the transmission oil, be sure to clean the
transmission oil strainer (1) with appropriate cleaning fluid.
3. If the oil strainer is deformed or broken, replace it.
■
• Be careful not to damage the transmission oil strainer parts
when installing.
W1047188
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet
A : Upper Level
B : Lower Level
(1) Transmission Oil Strainer
(2) O-ring
(3) Front Suction Pipe
To Next Page
Loading...
Need help?
General
