Kubota WSM F2880 User Manual

G-17
F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
G GENERAL
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
CAUTION
• Be sure to stop the engine and remove the key before
changing oil.
• Allow engine to cool down sufficiently. Oil can be hot and
may cause burns.
1. Place an oil pan underneath the engine.
2. To drain the used oil, remove the drain plugs (1) at the bottom of
the engine and drain the oil completely.
3. Screw in the drain plugs (1) and tighten.
4. Fill with new oil up to upper line on the dipstick (3).
IMPORTANT■
• When using an oil of different manufacture or viscosity from
the previous one, remove all of the old oil.
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
Refer to “LUBRICANTS, FUEL AND COOLANT” (See page
G-7).
W1030749
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine and remove the key before
changing the oil and the oil filter cartridge.
• Allow engine to cool down sufficiently; oil can be hot and
may cause burns.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Put a film of engine oil on the rubber seal of the new filter
cartridge.
3. Tighten the filter cartridge quickly until it contacts the mounting
surface.
4. Tighten the filter cartridge by hand an additional 1/2 turn only.
5. After the new filter is replaced, the engine oil normally decreases
a little. Check that the engine oil does not leak through the seal
and be sure to check the oil level on the dipstick.
6. Then, replenish the engine oil up to the prescribed level.
IMPORTANT
■
• To prevent serious damage to the engine. Use only a
genuine KUBOTA filter.
W1030949
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick
(A) Oil level is acceptable within this
range.
(1) Engine Oil Filter Cartridge
KiSC issued 04, 2006 A

Kubota WSM F2880 Specifications

General

Brand	Kubota
Model	WSM F2880
Category	Lawn Mower
Language	English