TRANSMISSION
L3560, L4060, L4760, L5060, L5460, L6060, WSM
3-S21
[2] GLIDE SHIFT TRANSMISSION (GST)
(1) Electrical Adjusting [GST Fine-adjustment with Electronic Instrument
Panel (Intellipanel)]
• The fine-adjustment function is a function to update the data of the memory device in the main ECU when
a sensor, a valve, and an electronic instrument panel which relates to the GST system are repaired or are
re-installed. There are three kinds of fine-adjustment functions in the GST system.
9Y1210824TRS0178US0
GST Lever Sensor Fine-adjustment (Setting the GST lever's
neutral position with its sensor)
• As for the fine-adjustment, make sure to set it correctly to
have the standard control thereafter.
• When the GST lever sensor, the main ECU or the electronic
instrument panel is replaced, this adjustment is required.
1. Set the GST shift lever to Neutral position.
2. While holding down the display mode switch (2), turn on the
main switch.
3. Mode selection display (a) is indicated on the LCD (1).
4. Press the display mode switch (2). The buzzer rings and the
marked display moves.
5. Select the Mode "E".
6. Hold down the display mode switch (2) for more than 2 seconds.
7. When "GST Lever Sensor Fine-adjustment Mode" is
displayed (b), release the display mode switch (2).
8. "Hold button for 3s more" is displayed (c).
9. Hold down the display mode switch (2) for more than 3 seconds
to preserves the adjustment value to the main ECU.
"Fine-adjustment Mode Complete'' is displayed (d).
10. Fine-adjustment preserves to main ECU has been input
correctly.
Turn off the main switch.
11. If "Out of setting position Error No. 70" shows up (e), the
GST lever sensor voltage is out of specifications.
• Make sure that GST lever is in the Neutral position.
• Check the GST lever sensor voltage in the Test Mode
(Mode A). If out of specifications, replace the sensor.
12. If "Not Complete" is displayed : Incorrect input. Repeat the
procedure.
13. Turn off the main switch.
9Y1210824TRS0179US0
(1) LCD (Liquid Crystal Display)
(2) Display Mode Switch
(a) Mode Selection Display
(b) Information Display
(c) Adjusting Display
(d) Correct Preserving Display
(e) Error Display
To Next Page
Loading...
Need help?
General