ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-S16
(1) Mode Selection
• To preform the testing of the electronic instrument panel
the operator must be seated on the tractor.
• Select a corresponded mode by the following procedure,
and do the test, the adjustment, the setting, and the
confirmation respectively.
1. While holding down the display mode switch (2), turn the main
switch to "ON" or "START" position.
2. Mode selection display (4) is indicated on the LCD (1).
3. Press the display mode switch (2). The buzzer rings and
marked display moved.
4. Hold down the display mode switch (2) for more than 2 seconds,
and the buzzer rings and marked display is selected.
• To save entire and review the conditions, usually hold
down the display mode switch (2) until the buzzer rings.
• When a setting has been saved or an adjustment mode in
any mode, be sure to turn off the main switch to end the
procedure.
(To be continued)
(1) Liquid Crystal Display (LCD)
(2) Display Mode Switch
(3) Auto Throttle Advance Switch for
HST
(4) Mode Selection Display
(A) Mode Selection Display for
Manual Transmission
(B) Mode Selection Display for GST
(C) Mode Selection Display for HST
To Next Page
Loading...
Need help?
General