Default Setting (System Menu)
8-175
8
5 Press the ļ² or ļ³ key to select [LAN Interface].
6 Press the
OK
key. LAN Interface appears.
7
Press the ļ² or ļ³ key to select the desired LAN
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
8
Press the
OK
key.
Completed.
is displayed and the
screen returns to the Network Setting menu.
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to Network Setup (LAN Cable Connection) on page 2-15
about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default setting is
Off
.
Use the procedure below to setup the TCP/IP (IPv6) setting.
1
In the Sys. Menu/Count. menu, press the ļ² or ļ³
key to select [System/Network], and press the
OK
key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in, and press [Login] (the
Right
Select
key).
To Next Page
Loading...
Need help?
General
