Lenze 8400 BaseLine C User Manual

Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05 117
6 I/O terminals
6.3 User-defined terminal assignment
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Possibility 2: Change terminal assignment by means of the signal flow shown
Procedure:
1. Go to the Application parameters tab.
2. Go to the Application Parameters tab and click on the Signal flow button in order to change to
the dialog level Overview  Signal flow.
3. In the bJogSpeed2 list field, set the selection "0: Not interconnected".
4. In the bSetQuickstop list field, set the "12: DigIn_bIn2" selection.
6.3.3 Changing the terminal assignment via configuration parameters
The preconfigured terminal assignment can be reconfigured via a bus system, with the keypad or
with the »Engineer« by means of configuration parameters.
• Each configuration parameter represents a signal input of a function block, a system block or an
application block.
• Each configuration parameter contains a selection list with output signals of the same type of
data.
• Logical linking is thus carried out by selecting the output signal for the corresponding signal in-
put.
In the following example, digital output 1 (LS_DigitalOutput.bOut1 input) is logically linked to the
status signal "Drive ready" (LA_nCtrl_bDriveReady output signal):
 Tip!
An overview of all configuration parameters and their Lenze setting in the different control
modes is provided in the chapter "Pre-assignment of the drive application
". ( 133)

Lenze 8400 BaseLine C Specifications

General

Brand	Lenze
Model	8400 BaseLine C
Category	Inverter
Language	English