Lenze 8400 BaseLine C User Manual

8 Diagnostics & error management
8.2 Drive diagnostics with the »Engineer«
146
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 Drive diagnostics with the »Engineer«
When an online connection to the controller has been established, the connected controller can be
diagnosed and relevant actual controller states can be displayed in a clearly arranged visualisation
using the »Engineer« :
 Information on the drive diagnostics with the integrated keypad can be found in the
chapter "Introduction" in the subchapter "Internal Keypad
":
LED status display
( 18)
Display messages
( 19)
Button Function
 Display all active sources of a controller inhibit.
 Display all active sources of a quick stop.
Resetting an error Acknowledge fault message (if the error cause has been eliminated).
Logbook... Display the
Logbook of the controller. ( 149)
Monitoring... Configure the
Monitoring. ( 151)
Device state... Display the internal state machine including the current device state.
Drive control... Display the bit assignment of the following control-related words:
• CAN control word (C136/2
)
• Cause of controller inhibit (C158
)
• Cause of quick stop QSP(C159
)
•Status word (C150
)
• Extended status word (C155
)
Device information... Display identification data, e.g. information on firmware version.

Lenze 8400 BaseLine C Specifications

General

Brand	Lenze
Model	8400 BaseLine C
Category	Inverter
Language	English