Lenze 8400 BaseLine C User Manual

10 Parameter reference
10.2 Parameter list | C00105
251
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00105
C00106
C00107
Parameter | Name:
C00105 | Deceleration time quick stop
Data type: UNSIGNED_32
Index: 24470
d
= 5F96
h
The set deceleration time determines the ramp slope at quick stop
• When the output frequency falls below the threshold set in C00019
, the DC injection brake DCB is activated.
Note:
The S-ramp time set in C00182
is also active with quick stop!
In order to reach the required deceleration time for quick stop, set the time accordingly lower in this parameter.
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 999.9 5.0 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00106 | Auto DCB: Hold time
Data type: UNSIGNED_32
Index: 24469
d
= 5F95
h
Hold time of the automatic DC injection brake
• The DC injection brake is applied for the time set here if the value falls below the speed setpoint set in C00019
.
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 999.0 0.5 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00107 | DCB: Hold time
Data type: UNSIGNED_32
Index: 24468
d
= 5F94
h
Maximum hold time of the manual DC injection brake
• In order not to overload the motor thermally, a time for automatic switch-off of the DC injection brake can be set
here.
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 999.0 999.0 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000

Lenze 8400 BaseLine C Specifications

General

Brand	Lenze
Model	8400 BaseLine C
Category	Inverter
Language	English