3 -25
▶ Before attaching or checking the PTO driven equipment,
- Always place the PTO switch in OFF position, and PTO gear lever in NEUTRAL
position.
▶ If the PTO switch is placed in MANUAL position, PTO rotates even if the
implement moves up to upper limit. Pay attention to the surroundings to prevent a
accident.
▶ Do not engage the PTO at high engine speed. Sudden engagement can cause
damage to some implements and PTO clutch. Engage PTO at low RPM, and then
raise the engine speed up.
Warning
(12) PTO switch
PTO mode switch
MHL
PTO mode switch
EHL
PTO switch
PTO switch
The engine starts only when PTO switch is
placed in OFF position for safety.
After starting the engine, you must comply with
the operation procedure of the PTO switch as
follow.
1. Place the PTO gear lever to desired position.
2. Select the PTO mode switch to “AUTO” or
“Manual” position.
3. Pull the PTO switch with pressing the lock
button of the switch to engage the PTO.
The PTO operation indicator shall be ON .
4. If you want to stop the PTO temporarily while
operating, push the PTO switch in OFF position.
The PTO shaft shall be stopped.
OFF
ON
To Next Page
Loading...
Need help?
General
