3 -30
Neutral
3-4. Power Shuttle System (PSS) (if fitted)
Power shuttle lever
Forward
Reverse
Neutral
(1) Power shuttle lever (PSS)
Your tractor has an advanced electro-hydraulic
forward and reverse system which controls the
movement (Forward/Reverse/Stop) of the tractor
by engaging or disengaging the multi-disk
clutches.
This system shall provide you more convenient
forward-reverse operation than mechanical
synchro-shuttle system.
To change the Forward/Reverse, after lifting up
the power shuttle lever, just push it forward or
pull it back without depressing clutch pedal.
Before reversing the tractor, lower engine rpm
and check behind you.
If transmission oil temperature is below
10℃(50℉), the neutral (N) indicator on the
instrument panel shall blink to inform you that
warm-up is needed. If the oil temperature goes
higher than 10℃(50℉), the indicator shall be
turned off automatically.
If the oil temperature is considerably lower than
proper level, a shock due to sudden engagement
of the power shuttle clutch may happen. Before
operating the power shuttle lever, be sure to
warm-up the engine and transmission oil
sufficiently in cold weather.
If shifting power shuttle lever forward or reverse
in the state of vacant driver’s seat, the tractor
does not move with alarming buzzer. HAVE TO
SEAT IN DRIVER’S SEAT.
If shifting power shuttle lever forward or reverse
when the parking brake is engaged, the parking
brake indicator shall blink with alarming buzzer.
Before shifting the shuttle lever, HAVE TO
RELEASE the parking lever.
Reverse
Forward
Parking brake indicator
FMI Code
SPN code
▶When starting or shifting the power shuttle lever on a slope, always press down the
brake pedals first, and release them at the moment when the vehicle starts. The
vehicle can be moved forward or slipped backward during the engaging time of the
clutch. It may cause roll-over accident. BE CAREFUL !
Warning
To Next Page
Loading...
Need help?
General
