LS tractor XR4140 User Manual

5 -31
(4) Checking Front axle oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around the oil check port and oil filling
inlet.
 Open the plug of oil check port and check if
there is oil leakage.
 If necessary, add new oil into the oil filling inlet.
(after 5~10 minutes later, check it again)
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil filling inlet
Oil check port
(3) Checking Transmission oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around oil filling inlet and pull the gauge
straight out.
 If oil level is between “Min” and “Max” marks of
oil gauge, it means ‘Proper amount’.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
▶ The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the transmission and hydraulic system. Clean around oil filling inlet
before opening the oil gauge.
Caution
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
(5) Battery check
 Refer to the chapter 5-14-(3), “Batter handling and Notices” in this manual. (See page 5-50)
(6) Air cleaner (Dry type)
 Refer to the chapter 5-6-(6) in this manual (See page 5-24).
▶ The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the transmission and hydraulic system. Clean around oil filling inlet
before opening the oil gauge.
Caution

LS tractor XR4140 Specifications

General

Brand	LS tractor
Model	XR4140
Category	Tractor
Language	English