LS tractor XR4140 User Manual

5 -37
5-10. Every 500 hour check
Drain plug
Oil check port
Oil filling inlet
(1) Changing Front axle oil
 Stop tractor on a level surface and apply parking
brake.
 Clean around oil filling inlet and drain plugs.
 Remove left/center/right drain plugs and oil filling
inlet to drain the oil completely.
 Wrap the sealing tape on the plugs and tighten
the drain plugs to its original position.
 Add new oil into the oil filling inlet.
 After about 5 minutes later, Unscrew the oil
check port plug, and check if the oil flows out.
 Tighten the oil filling inlet plug.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
(2) Changing Transmission oil
 Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.
 Clean around the oil filling inlet and drain plugs.
 Set a clean container under drain plugs and
remove them under the transmission and drain
the oil completely.
 Clean metal sludge stuck to the drain plugs and
tighten the drain plugs again with copper washer.
 Add new oil until the oil level is between MIN and
MAX mark of the oil gauge.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Drain plugs
Copper washers
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
▶ Contaminated oil may reduce
the durability of the
transmission and it can cause a
failure of the hydraulic system.
Clean around the oil filling inlet
and then pull the oil gauge.
Caution

LS tractor XR4140 Specifications

General

Brand	LS tractor
Model	XR4140
Category	Tractor
Language	English