Page 16 OM 780-2
CAUTION
After changing network settings, be sure to record the changes and save them in a safe location. We recommend
also writing it on the label provided on the inside front cover of the CSM panel, in order to avoid a lengthy
recovery procedure if the network settings are lost.
Connecting to the CSM’s User Interface
To use the CSM’s user interface to configure and monitor the chiller system use the following procedure. If the CSM was
placed on a LAN (see the previous section, Changing the CSM’s IP Address and Date/Time) and your computer has access
to the same LAN, you may skip to step 4.
To connect to the CSM’s user interface follow this procedure
1. Attach one end of a standard Category-5 Ethernet unshielded twisted par (UTP) patch cable to the Ethernet port on the
CSM (see Figure 48 for port location).
2. Attach the other end of the patch cable to an Ethernet Hub.
Note: If you do not have access to a hub, use an Ethernet crossover cable to connect the CSM directly to the network
connection on your PC.
3. Power up the CSM
4. From your PC, start Internet Explorer.
5. In the address bar on the top of your Internet Explorer page, type:
http://<IP Address>
Where <IP Address> is the IP Address of the CSM (e.g. 192.168.1.141). An “Enter Network Password” dialog box will
appear (see Figure 3).
6. Log on to the CSM with your user name and password, as it appears on the packing list. Typical defaults are User
Name = McQuay and Password = Password. Click OK. The CSM’s User Interface Main Screen will appear.
To Next Page
Loading...
Need help?
General
