10 TRAX ZP-AJ01E AJ0383DE
2 SAFETY
9.
High-voltage discharges and other sources of
strong electric or magnetic fields may interfere
with the proper functioning of heart pacemak-
ers. Persons with heart pacemakers should
obtain expert advice on the possible risks before
operating this equipment or being close to the
equipment during operation.
10.
All persons making or assisting in tests must
use all practical safety precautions to prevent
contact with energized parts of the test equip-
ment and related circuits. Also follow all local
and company safety requirements. Persons
actually engaged in the test must stand clear of
all parts of the complete high- voltage circuit,
including all connections, unless the test set is
de-energized and all parts of the test circuit are
grounded. Persons not directly involved with the
work must be kept away from test activities by
suitable barriers, barricades, or warnings.
11.
Safety is the responsibility of the user.
12.
Misuse of this high-voltage equipment can be
extremely dangerous.
13.
The purpose of this equipment is limited to use
as described in this manual. Do not use the
equipment or its accessories with any device
other than specifically described.
14.
Before making any connections, make sure that
the instrument is de-energized and that all parts
of the test circuit are properly grounded.
15.
Never connect more than one output at the
time. All outputs are energized by the same
amplifier and therefore all outputs are energized
simultaneously.
16.
Operation is prohibited in rain or snow.
17.
Do not use the test set in an explosive
atmosphere.
18.
A qualified operator should be in attendance
at all times while the test equipment is in
operation.
19.
Observe all safety warnings marked on the
equipment.
20.
Corrective maintenance must only be performed
by qualified personnel who are familiar with the
design and operation of the test set and the
hazards involved.
Maintenance
1.
DISCONNECT the MAINS plug before any
cleaning or maintenance.
2.
Maintenance should be performed only by
qualified personnel familiar with the hazards
involved with high-voltage test equipment.
3.
Read and understand Safety in the User Manual
before performing any service.
4.
Routine maintenance is all that is required for
these test sets. The cables and connector panel
should be inspected frequently to be sure all
connections are tight and all ground connec-
tions intact.
5.
The appearance of the test set can be main-
tained by occasional cleaning of the case,
panel and cable assemblies. The outside of the
carrying case can be cleaned with detergent and
water. Dry with a clean, dry cloth. The control
panel can be cleaned with a cloth dampened
with detergent and water. Do not allow water
to penetrate panel holes, because damage to
components on the underside may occur. A
household all-purpose spray cleaner can be used
to clean the panel. Polish with a soft, dry cloth,
taking care not to scratch the display screen
cover. The cables and mating panel receptacles
can be cleaned with isopropyl or denatured
alcohol applied with a clean cloth.
To Next Page
Loading...
Need help?
General
