Metrohm 912 User Manual

4.7 Menu dialogs
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
56
￭￭￭￭￭￭￭￭
912/913/914 Meter
￭ Custom (ESC-POS)
Roll printer with paper width 60 mm
￭ Epson TM-U220B
Roll printer with paper width 76 mm
￭ Universal (ESC-POS)
Universal roll printer with variable settings:
– Paper width
50 - 200 mm
– Print resolution
100 - 600 dpi
– Print type
Line or Matrix
4.7.7 Configuration
The Configuration menu dialog for all instrument settings is shown
below with the structure and the description.
Last decimal place
Selection dialog for selecting whether the Last decimal place is displayed for
the pH measured values with three digits at most.
Drift value monitoring is not influenced by this setting.
￭ on: Last decimal place is displayed.
￭ off: Last decimal place is not displayed.
Signal intensity DO
￭ on: default value
￭ off
Date
Editing dialog for entering the system date.
Date format: YYYY-MM-DD
Time
Editing dialog for entering the system time.
Time format: hh:mm:ss
Power off after
Editing dialog for entering the time for the function Power off after x
minutes. After this time, the instrument shuts down automatically or goes into
standby mode.
This function is disabled during time-dependent recording of measured values
with a set time interval.
￭ Default value: 15 / input range: 1 - 60, or
￭ off for continuous operation.
Turn off LCD after
Editing dialog for entering the time for the function Turn off LCD after x
minutes. The display turns off after this time and can be turned back on again
with any key other than the key.
￭ Default value: 15 / input range: 1 - 60, or
￭ auto for dimming after 20 seconds and switching off the display after
another 60 seconds.

Metrohm 912 Specifications

General

Brand	Metrohm
Model	912
Category	Measuring Instruments
Language	English