4.11 Issuing reports/measured values
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
66
￭￭￭￭￭￭￭￭
912/913/914 Meter
NOTICE
Measured value recording
Depending on the settings of the measured value criterion, the
recording of the measured value may take some time. During the
measurement, hold the sensor steady and do not touch the sam-
ple vessel with it.
For measurements that take longer, we recommend using a stand
to secure the sensor in place.
Finishing measurements
After the last measurement, rinse the sensor and follow the stor-
age instructions for the sensor.
4.11 Issuing reports/measured values
The 912/913/914 Meter supports the output of various printouts and
data transfers for displaying the calibration and measured values.
4.11.1 Printing out
The printouts are divided into various groups:
￭ Printing out values directly after generation:
– Calibration data
Calibration data can be printed out if on is selected under:
Menu ▶ Parameters X ▶ Calibration param. ▶ Report
– Measured values
Direct printing of the measured values can be done with the
or buttons.
￭ Printing out saved values in the following areas as reports:
– Calibration
– Sensors
– Configuration
– Parameters
– Measured values
Report data can be printed using the Report selection dialog under:
Menu ▶ Report
To Next Page
Loading...
Need help?
General
