Accutorr V Operating Instructions 0070-10-0699-02 3 - 45
Operation Creating a User Configuration
2. Once SAVE USER CONFIG is highlighted, press to save the new user
configuration.
3. When the confirmation request is displayed, press to confirm saving the new
configuration.
3.16.6 Setting a Default Power-on Configuration
The operator can select the default power-on configuration. Each time the Accutorr V is
turned on, it will use that default configuration.
To select a default power-on configuration:
1. Press (12) to display the SYSTEM SETUP dialog FIGURE 3-7.
2. Press (16) or (19) to select MAINTENANCE.
3. Once the MAINTENANCE is highlighted, press (18) to display the
MAINTENANCE dialog as shown in FIGURE 3-26.
4. Press (16) or (19) to select USER MAINTENANCE.
5. Once USER MAINTENANCE is highlighted, press (18) to display the Enter
Password dialog, as shown in FIGURE 3-27.
6. In the Enter Password dialog, press (18).
7. Press (16) or (19) to set the first password digit to 3.
8. Press (18).
9. Press (16) or (19) to highlight the second password digit.
10. Press (18).
11. Press (16) or (19) to set the second password digit to 2.
12. Press (18).
13. Press (16) or (19) to highlight the third password digit.
14. Press (18).
15. Press (16) or (19) to set the third password digit to 1.
16. Press (18).
17. Press (16) or (19) to highlight OK.
18. Press (18)to display the USER MAINTENANCE dialog as shown in FIGURE 3-28.
19. Press (16) or (19) to highlight SELECT CONFIG.
20. Once SELECT CONFIG is highlighted, press (18) to display the SELECT
CONFIG dialog as shown in FIGURE 3-29.
To Next Page
Loading...
Need help?
General
