Mindray VS 8 User Manual

VS 8/VS 8A Vital Signs Monitor Operator’s Manual 16 - 7
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on Log Out After Saving.
16.4.1.6 Setting whether to Discharge Patient Automatically after Saving Data
You can selects whether to automatically discharge the patient after saving data in Spot
Check mode. To do so, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on or off Discharge Patient After Saving.
16.4.1.7 Setting whether to Automatically Save NIBP Measurements
You can selects whether to automatically save the NIBP measurements after NIBP
measurement completes. To do so, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on or off Auto Save After NIBP Measurement.
16.4.2 Setting Items about Sending Data
16.4.2.1 Setting Clinician Login as Required for Sending Data
You can set clinician login as required for sending data. To do so, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on Clinician Required.
16.4.2.2 Enabling Clinician Login Verification before Sending Data
You can set the monitor to verify if the clinician login information matches with the
information in the database before sending data. To do so, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on Clinician Match Required.
16 - 8 VS 8/VS 8A Vital Signs Monitor Operator’s Manual
16.4.2.3 Setting whether to Automatically Clear Sent Data
You can select whether to clear the sent data after it is sent successfully. To do so, follow this
procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on or off Clear Sent Data After Sending.
16.4.2.4 Setting whether to Automatically Clear Local Patient List
You can select whether to clear the patient list saved on the monitor after the sending.
To do so, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Save&Send tab.
3. Switch on or off Auto Clear Local Patient List.
16.5 Changing the Alarm Settings
16.5.1 Setting Alarm Tone Properties
16.5.1.1 Setting the Minimum Alarm Volume
To set the minimum alarm volume, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Alarm tab. The Audio tab is displayed.
3. Set Minimum Alarm Volume.
16.5.1.2 Setting the Interval between Alarm Sounds
If you choose the ISO pattern, you can change the interval between alarm tones. To
change the interval between alarm tones, follow this procedure:
1. Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2. Select the Alarm tab. The Audio tab is displayed.
3. Set High Alarm Interval, Med Alarm Interval, and Low Alarm Interval.
Item Range Default
High Alarm Interval
3 s to 15 s 10 s
Med Alarm Interval
3 s to 30 s 20 s

Mindray VS 8 Specifications

General

Brand	Mindray
Model	VS 8
Category	Monitor
Language	English