Mitsubishi Outlander 2015 User Manual

NOTE
l
The rear window wiper will automatically
perform several continuous operations if the
gearshift lever or the selector lever is put in
the “R” position while the windscreen wip-
ers or the rear window wiper is operating.
(automatic operation mode)
After the automatic operation, the rear win-
dow wiper will stop operating if the knob is
in the “OFF” position. If the knob is in the
“INT” position, the rear window wiper will
return to the intermittent operation.
It is possible to set the rear window wiper to
perform the automatic operation only if the
gearshift lever or the selector lever is put in
the “R” position while the rear window wip-
er is operating with the knob in the “INT”
position.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
l
If the knob is in the “OFF” position, turn the
knob to the “INT” position twice quickly to
operate the rear window wiper continuously.
(continuous operation mode)
Turn the knob to the “OFF” position to stop
the rear window wiper continuous operation.
NOTE
l
The interval for intermittent operation can be
adjusted.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
Headlamp washer switch*
E00510101443
The headlamp washer can be operated with
the ignition switch or the operation mode in
ON or ACC and the lamp switch at the “
”
position.
Push the button once and the washer fluid
will be sprayed on to the headlamps.
NOTE
l
If the ignition switch or the operation mode
is in ON or ACC and the headlamps are on,
the headlamp washer operates together with
the windscreen washer the first time the
windscreen washer lever is pulled.
Precautions to observe when
using wipers and washers
E00507601196
l
If the moving wipers become blocked
partway through a sweep by ice or other
deposits on the glass, the wipers may
temporarily stop operating to prevent the
motor from overheating. In this case,
park the vehicle in a safe place, turn the
ignition switch to the “OFF” position or
put the operation mode in OFF, and then
remove the ice or other deposits.
The wipers will start operating again af-
ter the wiper motor cools down, so
check that the wipers operate before us-
ing them.
l
Do not use the wipers when the glass is
dry.
They may scratch the glass surface and
the blades wear out prematurely.
l
Before using the wipers in cold weather,
check that the wiper blades are not fro-
zen onto the glass. The motor may burn
out if the wipers are used with the blades
frozen onto the glass.
Wiper and washer switch
5-69
OGFE16E1
Instruments and controls
5

Mitsubishi Outlander 2015 Specifications

General

Brand	Mitsubishi
Model	Outlander 2015
Category	Automobile
Language	English