• ACEA classification:
“For service A1/B1, A3/B3, A3/B4 or
A5/B5”
NOTE
l
Use of additives is not recommended since
they may reduce the effectiveness of addi-
tives already included in the engine oil. It
may result in failure of the mechanical as-
sembly.
Diesel-powered vehicles
l
Select engine oil of the proper SAE vis-
cosity number according to the atmos-
pheric temperature.
l
Use engine oil conforming to the follow-
ing classification:
• ACEA classification:
“For service C1, C2, C3 or C4”
• JASO classification:
“For service DL-1”
If those classifications are not available,
contact a MITSUBISHI MOTORS Au-
thorized Service Point.
NOTE
l
Use of additives is not recommended since
they may reduce the effectiveness of addi-
tives already included in the engine oil. It
may result in failure of the mechanical as-
sembly.
Engine coolant
E01000503176
To check the coolant level
A transparent coolant reserve tank (A) is lo-
cated in the engine compartment.
The coolant level in this tank should be kept
between the “LOW” and “FULL” marks
when measured while the engine is cold.
*: Front of the vehicle
To add coolant
The cooling system is a closed system and
normally the loss of coolant should be very
slight. A noticeable drop in the coolant level
could indicate leakage. If this occurs, we rec-
ommend you to have the system checked as
soon as possible.
Engine coolant
10-07
OGFE16E1
Maintenance
10
To Next Page
Loading...
Need help?
General
