CAUTION
l
Neither control nor a warning are performed
in the following situation.
•
Something other than a vehicle ap-
proaches, such as a pedestrian.
•
When there is an abnormality in the sys-
tem (When the ACC detectes an abnor-
mality, “ACC SERVICE REQUIRED” is
indicated.)
l
The ACC makes neither acceleration nor de-
celeration control and only issues warning in
the following situation.
•
The vehicle in front is in a park or moving
at an extremely slow speed.
l
The ACC may not be able to maintain the
set speed or the distance to a vehicle in front
and may not alert the driver, if the system
cannot detect the vehicle in front properly, in
the following situations.
•
When a vehicle cuts in front of your vehi-
cle very closely.
•
When a vehicle in front is offset to the left
or right.
•
When a vehicle in front is towing a trailer.
•
The vehicle in front is moving at a speed
much lower than your vehicle’s.
•
A motorcycle or a bicycle.
•
A freight trailer that is not carrying a con-
tainer.
•
The vehicle has a protruding load from
the carrier.
•
The vehicle has a low vehicle height.
•
The vehicle has an extremely high ground
clearance.
CAUTION
•
When there is repeated steep uphill and
downhill driving.
•
When driving on an irregular or uneven
road surface.
•
When being driven in a tunnel.
•
When you are carrying extremely heavy
loads in the rear seats or luggage area.
•
After the engine starting for a while.
•
When driving in curved sections of road
including their entrance/outlet or running
beside a closed lane in a traffic work or
similar zone.
•
When the cover part in front of the sensor
and the sensor become dirty or have snow
and ice* adhering to it.
•
When water, snow or sand on the road are
extorted by the vehicle in front or an on-
coming vehicle*.
*: After the ACC control has been cancelled auto-
matically due to detection of a state of decline in
performance, the ACC will not operate in the tem-
porary condition and will inform the driver by
buzzer and indication. When the ACC is in the
state in which it can operate, indication is cancel-
led.
Should the indications not be cancelled, then there
is a possible abnormality in the system.
Please contact a MITSUBISHI MOTORS Au-
thorized Service Point.
Cruise control switch
E00634801025
1- “ACC ON/OFF” switch
Used to turn on and off ACC or the cruise
control function.
2- “SET -” switch
Used to set a desired speed and to reduce the
set speed.
3- “RES +” switch
Used to make ACC operate at the originally
set speed and also to increase the set speed.
4- “CANCEL” switch
Used to cancel the control function of ACC
or the cruise control.
5- ACC distance switch
Adaptive Cruise Control System (ACC)*
6-83
OGFE16E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
