EasyManuals Logo

Mitsubishi Outlander 2015 User Manual

Mitsubishi Outlander 2015
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #412 background imageLoading...
Page #412 background image
1. Park the vehicle on a horizontal surface.
2. Switch off the engine.
3. Wait a few minutes.
4. Remove the dipstick and wipe it with a
clean cloth.
5. Reinsert the dipstick as far as it goes.
6. Remove the dipstick and read the oil lev-
el, which should always be within the
range indicated.
7. If the oil level is below the specified
limit, remove the cap located on the cyl-
inder head cover and add enough oil to
raise the level to within the specified
range. Do not overfill to avoid engine
damage. Be sure to use the specified en-
gine oil and do not mix various types of
oil.
8. After adding oil, close the cap securely.
9. Confirm the oil level by repeating step 4
to 6.
CAUTION
l
In diesel-powered vehicles, when burning
away and removing soot accumulated in the
DPF, fuel can mix with the engine oil and an
increase in the engine oil level may occur.
This does not indicate an abnormality.
However, if the engine oil level is at or over
the “X” mark (B) on the engine oil dipstick
(A), change the engine oil.
NOTE
l
For 3000 models, to check the oil level, pull
the dipstick straight out and check the oil
level by checking the upper surface of the
dipstick.
l
The engine oil will deteriorate rapidly if the
vehicle is subjected to severe conditions, re-
quiring earlier oil replacement.
Please refer to the maintenance schedule.
l
For information on how to dispose of used
engine oil, refer to page “Safety and disposal
information for used engine oil” on page
2-06.
Recommended engine oil vis-
cosity
Petrol-powered vehicles
l
Select engine oil of the proper SAE vis-
cosity number according to the atmos-
pheric temperature.
SAE 0W-20*, 0W-30, 5W-30, and
5W-40 engine oils can only be used if
they meet ACEA A3/B3, A3/B4 or
A5/B5 and API SM (or higher) specifi-
cations.
*: Vehicles to comply with the Euro 4
regulation (Except for 3000 models)
l
Use engine oil conforming to the follow-
ing classification:
API classification: “For service SM”
or higher
ILSAC certificated oil
Engine oil
10-06
OGFE16E1
Maintenance
10

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Outlander 2015 and is the answer not in the manual?

Mitsubishi Outlander 2015 Specifications

General IconGeneral
BrandMitsubishi
ModelOutlander 2015
CategoryAutomobile
LanguageEnglish

Related product manuals