Catalytic converter*
E01000202466
The exhaust gas scavenging devices used
with the catalytic converter are extremely ef-
ficient for the reduction of noxious gases.
The catalytic converter is installed in the ex-
haust system.
It is important to keep the engine properly
tuned to ensure proper catalyst operation and
prevent possible catalyst damage.
WARNING
l
As with any vehicle, do not park or oper-
ate this vehicle in areas where combusti-
ble materials such as dry grass or leaves
can come in contact with a hot exhaust
since a fire could occur.
l
Paint should not be applied to the catalyt-
ic converter.
NOTE
l
Use fuel of the type recommended in “Fuel
selection” on page 2-02.
Bonnet
E01000304155
To open
1. Pull the release lever towards you to un-
lock the bonnet.
2. Raise the bonnet while pressing the safe-
ty lock.
NOTE
l
Only open the bonnet when the wipers are in
the parked position. In any other position,
the wipers could damage the paint or bonnet.
3. Support the bonnet by inserting the sup-
port bar in its slot.
CAUTION
l
Note that the support bar may disengage the
bonnet if the open bonnet is lifted by a
strong wind.
l
After inserting the support bar into the slot,
make sure the bar supports the bonnet se-
curely from falling down on to your head or
body.
To close
1. Unlatch the support bar and clip it in its
holder.
Catalytic converter*
10-04
OGFE16E1
Maintenance
10
To Next Page
Loading...
Need help?
General
