Mitsubishi Q02HCPU User Manual

5
MEMORIES AND FILES USED IN CPU MODULE
5.2 High Performance Model QCPU, Process CPU, Redundant CPU, Universal Model QCPU
5.2.7 Writing data to standard ROM and Flash card using GX Developer
5 - 39
1
Overview
2
Performance Specification
3
Sequence Program Configuration and Execution Conditions
4
I/O Nunber Assignment
5
Memories and Files Handled by CPU Module
6
Functions
7
Communication using built-in Ethernet ports of CPU module
8
Communication with Intelligent Function Module
5.2.7 Writing data to standard ROM and Flash card using GX Developer
(1) Methods and applications of writing data to the standard ROM and Flash
card
Figure 5.27 shows the methods of writing data to the standard ROM and Flash card.
(a) Method using [Write the program memory to ROM...] of GX Developer
The data in the program memory are batch-written to the standard ROM or Flash
card.
Select [Online] [Write to PLC (Flash ROM)] [Write the program memory to
ROM] to execute writing with this method.
Note5.8
Writing the program memory to ROM is used in the following cases.
• When performing debugging in the program memory program, copying the
debugged data to the standard ROM or Flash card, and executing boot run
( Section 5.2.9)
• When saving the program memory data into the standard ROM or Flash card
without battery backup.
(b) Method using [Write to PLC (Flash ROM)] of GX DeveloperNote8
The files specified in GX Developer are batch-written to the standard ROM or
Flash card.
Select [Online] [Write to PLC (Flash ROM)] [Write the program memory to
ROM] to execute writing with this method.
Note5.8
• When storing the parameters, device initial values and device comments,
which volume is too large to be saved in the program memory, to the
standard ROM or Flash card.
• When using the file registers stored on the Flash card.
Figure 5.27 Methods of writing data to the standard ROM and Flash card
Note8
Program
memory
Write
standard
ROM
Flash
card
Write
Write by writing the program
memory to ROM ( (a) below)
CPU module
GX Developer
Write by write to PLC (Flash
ROM) ( (b) below)
Universal
UD
Note5.8
The Universal model QCPU cannot write data to the standard ROM by [Write the program
memory to ROM...] and [Write to PLC (Flash ROM)].
Universal
UD
Note5.8
Universal
UD
Note5.8

Mitsubishi Q02HCPU Specifications

General

Brand	Mitsubishi
Model	Q02HCPU
Category	Controller
Language	English