Mitsubishi Q02HCPU User Manual

10
DEVICE EXPLANATION
10.11 Interrupt pointer (I)
10.11.1 List of interrupt pointer Nos and interrupt factors
10 - 100
9
Parameters
10
Device Explanation
11
CPU Module Processing Time
12
Procedure for Writing Program to CPU ModuleAppendicesIndex
10.11.1 List of interrupt pointer Nos and interrupt factors
The following table lists the interrupt pointer Nos. and interrupt factors of each CPU
module.
(1) Basic model QCPU
* 1 : The time-out period of the internal timer is a default value.
It can be changed in 1ms units within the range 2ms to 1000ms in the PLC system setting of the
PLC parameter dialog box.
* 2 : To use the intelligent function module interrupt, the intelligent function module setting (interrupt
pointer setting) is required in the PLC system setting of the PLC parameter dialog box. (Refer to
Section 6.23 for the interrupt from the intelligent function module.)
* 3 : Among I50 to 127, I50 has the highest priority (priority 21) and I127 has the lowest priority (priority
98).
Table10.22 Interrupt pointer No. and interrupt factor list (Basic model QCPU)
I No. Interrupt factors
Priority
level
I0
Interrupt module (QI60)
1st point 5
I1 2nd point 6
I2 3rd point 7
I3 4th point 8
I4 5th point 9
I5 6th point 10
I6 7th point 11
I7 8th point 12
I8 9th point 13
I9 10th point 14
I10 11th point 15
I11 12th point 16
I12 13th point 17
I13 14th point 18
I14 15th point 19
I15 16th point 20
I16 to 27 N/A -- --
I28
Internal timer
*1
100ms 4
I29 40ms 3
I30 20ms 2
I31 10ms 1
I32 to 49 N/A -- --
I50 to 127
*2*3
Intelligent function module/
Interrupt module (QI60)
Set which intelligent
function module/interrupt
module (QI60) is used with
parameters.
21 to 98

Mitsubishi Q02HCPU Specifications

General

Brand	Mitsubishi
Model	Q02HCPU
Category	Controller
Language	English