104 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
ENGLISH
Fuel System ASSEMBLY
104 / 195
ASSEMBLY
24 Fuel System
24.1 Fuel injection nozzle
installation
1. Put the gasket on the nozzle.
2. Put the nozzle assembly in position in the cylinder
head and tighten it to the specified torque.
24.2 Fuel injection pump
installation
Put the pump in position on the cylinder block and
tighten the bolts that hold the pump to the specified
torque.
24.3 Flyweight assembly
installation
Put the flyweight assembly in position on the rear end
of the fuel injection pump camshaft and tighten the
sliding sleeve shaft to the specified torque.
Figure 167 Installing fuel injection nozzle
Gasket
Tightening torque
5.5 ± 0.5 kgf·m
(40 ± 4 lbf·ft)
[54 ± 5 N·m]
Figure 168 Installing fuel injection pump
Figure 169 Installing flyweight assembly
Tightening torque
3.6 ± 0.6 kgf·m
(26 ± 4.3 lbf·ft)
[35 ± 6 N·m]
To Next Page
Loading...
Need help?
General
