89 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
Cylinder Block, Crankshaft, Pistons and
Oil pan
ENGLISH
ASSEMBLY
20.9 Oil screen installation
1. Lay the cylinder block with the bottom (oil pan
side) up.
2. Install the oil screen in position.
20.10 Oil pan installation
1. Clean the mating surfaces of the oil pan and
cylinder block and coat them with Three Bond
1207C.
Figure 131 Installing oil screen
NOTE
The oil screen must be installed in position so that it is
below the oil level line and away from the oil pan.
Figure 132 Coating mating surfaces with adhesive
Figure 133 Oil pan for S4L and S4L2 engines
NOTE
Squeeze out a 4 mm (0.2 in.) thick bar of sealing
compound (Three Bond) from the tube and put it on
the flange of the oil pan as shown.
To Next Page
Loading...
Need help?
General
