Mitsubishi S3L User Manual

49 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
Timing Gears and Flywheel
ENGLISH
DISASSEMBLY
t
15.6 Crankshaft pulley removal
1. Install two safety bars (M12 x 1.25) into the
threaded holes in the rear end of the crankshaft.
Put a bar between the safety bars to hold the
crankshaft to prevent it from rotating.
2. Remove the crankshaft pulley.
t
15.7 Timing gear case removal
Remove the bolts that hold the timing gear case in
position and remove the case.
t
15.8 Timing gear backlash
measurement
Measure the backlash of each gear and keep a record
of it for correct installation. Replace the gears if the
backlash exceeds the limit.
Unit: mm (in.)
Figure 43 Removing crankshaft pulley
WARNING
When removing the crankshaft pulley, be prepared to
stop the job in case the bar slips off the crankshaft to
prevent injury.
Figure 44 Front plate attaching bolts
CAUTION
The front plate is bolted inside the timing gear case.
Do not attempt to remove this plate along with the
timing gear case by tapping.
Figure 45 Measuring timing gear backlash
Item Standard Limit
Timing gear backlash
Crankshaft gear and
idler gear
0.04 to 0.12
(0.001 6 to 0.004 7)
0.30
(0.011 8)
Idler gear and
camshaft gear
Idler gear and fuel
injection pump
camshaft gear
Camshaft gear and
P.T.O. gear
0.08 to 0.19
(0.003 1 to 0.007 5)
Fuel injection pump
camshaft gear and oil
pump gear
0.07 to 0.20
(0.002 8 to 0.007 9)

Mitsubishi S3L Specifications

General

Brand	Mitsubishi
Model	S3L
Category	Engine
Language	English