127 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
ALTERNATOR
ENGLISH
ELECTRICAL SYSTEM
3. To install the new brushes, put them in position in
the brush holder and solder the leads to the
brushes.
30.3 Assembly
Follow the reverse of disassembly and use the
procedure that follows.
1. The rear bearing has a groove for the snap ring.
Install the snap ring in this groove, making sure its
tab is in the deep portion of the groove.
2. When installing the new rear bearing, put it in
position with the side that has a groove toward the
slip rings of the rotor.
3. To install the rear bearing in the rear bracket, heat
the rear bracket.
4. Before installing the rotor in the rear bracket, insert
a wire-shaped tooling into the hole in the rear
bracket to lift the brushes off the slip rings.
Remove the tooling after the rotor has been
installed in position.
Figure 195 Installing new brushes
Figure 196 Assembling alternator
Wire-shaped
tooling
Rear bracket
Wire-shaped
tooling
Brushes
To Next Page
Loading...
Need help?
General
