105 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
Fuel System
ENGLISH
ASSEMBLY
24.4 Sliding sleeve installation
Install the sliding sleeve on the sliding sleeve shaft and
make sure the sleeve moves freely.
24.5 Governor assembly
installation
1. Install the governor assembly in position while
putting the tie rod and spring into position in the
injection pump.
2. Install the tie rod to the pin of the control rack and
secure it with the tie rod spring.
3. Install the tie rod cover in position.
24.6 Fuel injection line installation
1. Put the fuel leak-off line in position and connect it
to the fuel injection nozzles.
2. Put the fuel injection lines in position and connect
them to the fuel injection pump. Install the clamps.
Figure 170 Installing sliding sleeve
Figure 171 Installing governor assembly
Figure 172 Installing fuel injection lines
To Next Page
Loading...
Need help?
General
