115 / 195
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004
STARTER
ENGLISH
ELECTRICAL SYSTEM
ELECTRICAL SYSTEM
29 STARTER
29.1 Disassembly
Disassembly sequence
1. Pinion set
2. Solenoid switch
3. Rear bracket
4. Brush holder
5. Yoke
6. Armature
7. Ball bearing
8. Ball
9. Seal set
10. Reduction gears
11. Lever set
12. Washer set
13. Gear shaft
14. Internal gear
15. Overrunning clutch
16. Front bracket
Figure 183 Starter component parts
Abnormal
rotation
Roughness, burns, or stepped
wear on commutator surface;
worn or damaged gear
Brush powder deposits,
uneven wear, poor brush
movement in holder
Incorrect installation of
pole pieces and field
coils
Broken or
damaged pinion
O-rings and snap rings are not reusable.
îîCAUTION
The pinion must be removed before removal or
replacement of the following parts:
1. Front bracket
2. Reduction gears
3. Overrunning clutch
To Next Page
Loading...
Need help?
General
