• Press the Menu Select button directly below
LNum to go to the last number dialed.
• Use the keypad to enter the required ID.
• Press the Menu Select button directly below
Send to initiate command.
If the receiving radio does not have encryption key
to decrypt the received command, your radio
display shows Ack received.
If the receiving radio does not have encryption key
to decrypt the received encrypted command, your
radio display shows Decrypt failed.
If the receiving radio is powered off, your radio
display shows No Acknowledgement.
Once the receiving radio received the command, its
screen locked and request for password.
Note: To un-stun a radio, follow the procedure in
Unlocking Your Radio on page 124.
Radio Kill
This feature allows you to render your radio or
another radio inoperable if the radio is misplaced or
lost. When a radio is killed, the display turns blank
and all functions of the radio are not usable.
The killed radio can only be recovered from KILL with
a special device. Consult an authorized and qualified
technician for details.
Using Remote Kill to Kill Another Radio
Remote Kill allows you to render another radio
inoperable by sending an over the air command using
the menu on your radio.
1
or to Kill.
2 Press the Menu Select button directly below
Kill.
The display shows Enter Password.
3 Use the keypad to enter your Tactical Inhibit
Encode Password.
4
Press the Menu Select button directly below Ok.
The display shows radio Contact IDs.
5 Perform one of the following actions:
• or to the required ID.
• Press the Menu Select button directly below
LNum to go to the last number dialed.
• Use the keypad to enter the required ID.
To Next Page
Loading...
Need help?
General
