Motorola APX 4000 User Manual

Selecting a Channel via Channel Search
Button
This feature allows you to do a quick search for a
specific channel in your radio by keying in the alias of
the channel. If the name matches, your radio prompts
the first found matched channel name.
1 Perform one of the following actions:
• Press the preprogrammed Channel Search
button.
•
or to CSrh and press the Menu Select
button directly below CSrh.
A blinking cursor appears on the Channel Search
screen.
2 Use the keypad to type or edit your channel
name.
3 To initiate searching, press the Menu Select
button directly below CSrh once the entry is done.
To exit this procedure, press the Menu Select
button directly below Cncl.
The display shows
Searching. Once found, the
display shows the matched channel name and the
radio changed its transmission to the selected
channel.
If the radio is triggered to search for an empty entry,
the display shows Invalid entry. Repeat step 2 to
search again.
If the entry does not match, the display shows
Channel name not found. Repeat step 2 to search
again; or press or the Menu Select button
directly below Exit to exit.
Mode Select Feature
Mode Select allows a long press to save the current
zone and channel of your radio to a programmable
button, keypad button, or a softkey; then once
programmed, the short-press of that button or softkey
changes the transmission to the saved zone and
channel.
There are two methods to save the selected zone and
channel:
• Softkeys
General Radio Operation
64
English

Motorola APX 4000 Specifications

General

IP Rating	IP67
Operating Temperature	-30°C to +60°C
GPS	Optional
Frequency Range	VHF: 136-174 MHz, UHF: 380-470 MHz, 450-520 MHz
Power Output	VHF: 1-5W; UHF: 1-4W
Digital Protocol	APCO P25
Dimensions	5.2 x 2.4 x 1.5 inches (without battery)