The following procedure guides you to exit the text
message received.
Press the Menu Select button below Exit or
to return to Home screen.
The other operations are same as normal dynamic
regroup command.
When the radio exits the Geofence area, your radio
reverts to original channel or newly assigned
talkgroup. The radio display shows the new channel
together with Voice Announcement to indicate the
changes. Voice Announcement of the new channel
only works if that channel is configured with Voice
Announcement.
Trunking System Controls
Using the Failsoft System
The failsoft system ensures continuous radio
communications during a trunked system failure. If a
trunking system fails completely, the radio goes into
failsoft operation and automatically switches to its
failsoft channel.
During failsoft operation, your radio transmits and
receives in conventional operation on a
predetermined frequency. You hear a medium-
pitched tone and the display shows Failsoft.
When the trunking system returns to normal
operation, your radio automatically leaves failsoft
operation and returns to trunked operation.
To continue, in Failsoft, to communicate with other
talkgroups, refer to the following procedure.
1 Rotate the Mode Knob to change to a different
repeater frequency.
2 Press the PTT button to talk, and release the
button to listen.
Out-of-Range Radio
When your radio goes out of the range of the system,
it can no longer lock onto a control channel.
You hear a low-pitched tone and/or the display shows
the currently selected zone/channel combination and
Out of range. Your radio remains in this out-of-
range condition until it locks onto a control channel, it
locks onto a failsoft channel, or it is turned off.
To Next Page
Loading...
Need help?
General
