4 - 8 MC3000 User Guide
LED Charge Indications
The Spare Battery Charging LEDs indicate the spare battery charging status. The Spare Battery Charging LEDs
are arranged in the same pattern as the spare battery charging slots so that the charging status of each battery can
be identified. See Table 4-1 on page 4-4 for charging status indications.
Cables
The cables are available with a variety of connection capabilities.
MC3000 Communication/Charge cables:
• Provide the mobile computer with operating and charging power when used with the Symbol approved power
supply.
• Synchronize information between the mobile computer and a host computer. With customized or third party
software, it can also synchronize the mobile computer with corporate databases.
• Provide serial connection through the serial pass-through port for communication with a serial device, such
as a host computer. For communication setup procedures, refer to the MC3000 Integrator Guide.
• Provide USB connection through the USB pass-through port for communication with a USB device, such as
a host computer. For communication setup procedures, refer to the MC3000 Integrator Guide.
The following MC3000 Communication/Charge cables are available:
• Serial (RS232) Charge cable (9-pin D female with power input receptacle)
• USB Client Charge cable (standard-A connector and a barrel receptacle for power).
Dedicated Printer cables, provide communication with a dedicated printer.
The following printer cables are available directly from the printer manufacturer:
• O’Neil printer cable
• Zebra printer cable
• Monarch printer cable.
CAUTION Use only a Symbol approved power supply output rated 5.4 VDC and minimum 3 A. Use of an alternative
power supply will void the product warranty and may cause product damage. See Appendix C, Regulatory
for the power supply regulatory compliance statement.
To Next Page
Loading...
Need help?
General