Native Instruments TRAKTOR KONTROL S2 User Manual

7.8.1 Single Mode and Group Mode
In TRAKTOR, each FX Unit can work in two different modes:
▪ Group
mode
: Each FX Unit boards three different FX chained in series. Each FX can be
controlled by one knob and one button.
▪ Single mode: Each FX Unit boards a single FX, which can be fine-tuned via the three
knobs and three buttons of the FX Unit.
As a consequence, the control elements on an FX Unit will have different functions, depending
on the current mode of this FX Unit.
You can set both modes in TRAKTOR's Preferences > Effects > FX Panel Mode.
7.8.2 FX Unit Reference
The following table sums up the functionality of each control element in the FX Unit.
Control element Single mode Group mode
FX On button Normal: activates/deactivates FX Unit
globally (lit when activated).
SHIFT: selects next FX from FX list (as
set in Preferences > Effects > FX Pre-
Selection).
Normal: not used.
SHIFT: loads a set of three predefined FX
(as set in Preferences > TRAKTOR KON-
TROL S2 > S2 Control Options > Direct
FX 1-3).
FX DRY/WET knob Adjusts the ratio between unprocessed (dry) signal and processed (wet) signal.
FX Knob 1-3 FX parameter 1-3 (FX-dependent). Parameter for 1st, 2nd, and 3rd FX.
FX Button 1-3 FX Button 1: resets all FX parameters
to their default value.
FX Buttons 2 and 3: FX-dependent (lit
when activated).
SHIFT + button: loads a predefined FX
(as set in Preferences > TRAK-
TOR KONTROL S2 > S2 Control Op-
tions > Direct FX 1-3).
Activates/deactivates FX slot 1-3 (lit when
slot activated).
SHIFT + button: loads in this slot the next
FX from FX list (as set in Preferences > Ef-
fects > FX Pre-Selection).
Hardware Control Reference
Using the FX Units
Traktor Kontrol S2 - Manual - 128

Native Instruments TRAKTOR KONTROL S2 Specifications

General

Brand	Native Instruments
Model	TRAKTOR KONTROL S2
Category	DJ Equipment
Language	English