10.3 Loose Jog Wheel Top Plate
The flat, round, push-sensitive surface of the jog wheels on your TKS2 was designed to be
easily replaceable. Due to heavy shocks or extreme vibration during travelling, in some rare
cases a jog wheel top plate might become loose or detached from the controller.
It can easily be reattached to the base of the jog wheel. To do this:
1. Align the connector pins on the bottom of the top plate with the corresponding clips on
the jog wheel base.
2. Hold the rubber rim of the wheel steady with one hand.
3. Use the other hand to push the plate down into the round central area of the jog wheel
and twist the plate around to the left (anti-clockwise) until the pins click back into the
clips on the base (you may hear a clicking sound).
Once the plate has clicked back into place, it should be securely fastened to the unit. If it is
still loose, try running through the procedure again. Although it may not be necessary for opti-
mum use, we recommend recalibrating your jog wheels after detaching and reattaching the jog
wheel top plate. For further details on jog wheel calibration, please refer to the separate Jog
Wheel Calibration Guide in the TRAKTOR 2 documentation folder. The guide was initially writ-
ten for the TRAKTOR KONTROL S4, but jog wheel calibration for both devices employs the ex-
act same methods.
10.4 TRAKTOR Crashes
In
case
of a crash during runtime, please contact the Native Instruments technical support
team and send them your crashlog. You will find the crashlog in the following folders:
▪ Windows: \My Documents\Native Instruments\Traktor 2\Crashlogs\
▪ Mac OS X: Users/~/Library/Logs/CrashReporter/
Troubleshooting and Help
Loose Jog Wheel Top Plate
Traktor Kontrol S2 - Manual - 156
To Next Page
Need help?
General
