Neptune Systems AquaController Apex Classic User Manual

Apex Classic Setup and Programming Guide v2.2 Page 107
6
1.2
seconds
1.2
seconds
8
1.8
seconds
1.7
seconds
Table 5- Pump Profile Timing to Resonate
Pump_R <Real Pump Outlet>
Set Resonate
You may have to adjust the times in the Profile for your specific aquarium but
these settings should be good starting point.
WARNING: This type of program with a sufficiently sized pump can create
LARGE waves that could overflow the sides of your aquarium.
ALTERNATE WITH VARIABLE SPEED PUMPS
One possible use for Profiles and variable speed Tunze Streams Pumps is to
create waves from one side of the tank, then switch to the other side and create
waves of flow from that side of the tank. With the AquaController Apex, this is
quite simple. This program also will reduce the flow to 30% at night and shut
down the pumps when Feed Timer A is activated. Let’s start with the Profiles
needed. Separate Left and Right Profiles are created so the maximum and
minimum flows can be adjusted separately.
R_Streams
L_Streams
Night
Synchronize =
OFF
Divide by 10 =
OFF
Initial off time
= 3
On time = 3
Off time = 5
Min Intensity
= 30
Max Intensity
= 100
Synchronize =
OFF
Divide by 10 =
OFF
Initial off time
= 3
On time = 3
Off time = 5
Min Intensity
= 30
Max Intensity
= 100
Synchronize =
OFF
Divide by 10 =
OFF
Initial off time
= 3
On time = 3
Off time = 5
Min Intensity
= 30
Max Intensity
= 30

Neptune Systems AquaController Apex Classic Specifications

General

Brand	Neptune Systems
Model	AquaController Apex Classic
Category	Control Unit
Language	English