Apex Classic Setup and Programming Guide v2.2 Page 81
WARNING: Initializing memory will result in resetting the AquaController
Apex programming information back to the factory default sate. YOUR
PROGRAMMING WILL BE ERASED. Make sure you save your configuration
information by following the instructions in the section titled Load/Save
Configuration and you are sure you know what you are doing before using these
utilities.
Initialize All - resets all configuration settings back to the factory default values
including the AquaBus device table, outlet configuration, and Profile
configuration.
Apex Display: System – Init Memory – Init All – confirm that you wish to
initialize all memory back to default factory values by pressing the Yes
button.
Web Interface: This option is not available from the Web Interface.
Initialize AquaBus - resets the AquaBus Device Table back to the factory default
values.
Apex Display: System – Init Memory – Init AquaBus Dev – confirm that
you wish to initialize selected memory back to default factory values by
pressing the Yes button.
Web Interface: This option is not available from the Web Interface.
Initialize Outlets - resets the Outlet configuration back to the factory default
values.
Apex Display: System – Init Memory – Init Outlets – confirm that you
wish to initialize selected memory back to default factory values by
pressing the Yes button.
Web Interface: This option is not available from the Web Interface.
Initialize Profiles - resets the Profile settings back to the factory default values.
Apex Display: System – Init Memory – Init Outlets – confirm that you
wish to initialize selected memory back to default factory values by
pressing the Yes button.
Web Interface: This option is not available from the Web Interface.
SELF TEST
The self test function is used to check basic functionality of the Apex Base
Module. If the base module passes the diagnostic, the word “Passed” will be
To Next Page
Loading...
Need help?
General