Apex Classic Setup and Programming Guide v2.2 Page 18
To: Address
Apex Display: System – Email Setup – To address – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the To Address
field and type the appropriate email address, press the Update Network
Settings button to save changes.
Alternate To: Address
Apex Display: System – Email Setup – Alt to address – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the To Address
field and type the appropriate email address, press the Update Network
Settings button to save changes.
Email retransmit delay
This is the period of time (in minutes) between re-sending alarm emails when
alarm conditions continue to be true.
Apex Display: System – Email Setup – ReEmail delay – use the up/down
arrows to change the delay time, when done, press OK.
Web Interface: Configuration – Network setup – click in the Re-email
delay (minutes) field and type the appropriate number of minutes, press
the Update Network Settings button to save changes.
ENABLE/DISABLE EMAIL AUTHENTICATION
Some email providers, especially non-ISP providers, require authentication before
access to the SMTP server is granted. If Email Authentication is enabled, the
credentials from the User Name and User Password fields are used to
authenticate with the SMTP server.
Apex Display: System – Email Setup – Email Auth: – push the Select
button to toggle authentication on and off.
Web Interface: Configuration – Network setup – click the Enabled or
Disabled radio button next to Email Authentication, press the Update
Network Settings button to save changes.
To Next Page
Loading...
Need help?
General