Apex Classic Setup and Programming Guide v2.2 Page 82
displayed. If your base module fails the Self test, please contact Neptune Support
through one of the methods listed in Appendix 5 – Troubleshooting and Help. The
Self Test screen is also an easy way to check the firmware version and date
installed as well as the Base Module serial number.
To perform the Self Test:
Apex Display: Self Test
Web Interface: This option is not available from the Web Interface.
LOAD/SAVE CONFIGURATION
The AquaController Apex Load/Save Configuration function is used to backup and
restore your AquaController programming and configuration information. The
Save Configuration function is used to backup all information into a single file to
be stored on your computer. You should save your configuration before making
drastic configuration changes, upgrading firmware, adding or removing modules,
etc. just in case you need to restore your AquaController to a previously, known
good state.
To Save the AquaController Apex configuration:
Apex Display: This option not available from the Apex Display.
Web Interface: Configuration – Load/Save – in the Save Apex
Configuration box near the bottom of the page, click the Save Configuration
button, follow the prompts to save the configuration file.
Figure 12 - Load Save screen
To Next Page
Loading...
Need help?
General