To Next Page

To Previous Page

Apex Classic Setup and Programming Guide v2.2 Page 25

PROBE MODULE 2

AquaController Apex Probe Module 2 (PM2) adds a Temperature and Conductivity

ports to the Apex system. This module connects anywhere on the AquaBus and

includes 2 AquaBus ports for flexible connection options. PM2 also includes 6

digital inputs for connecting float switches, sensors, etc. PM2 temperature and

Conductivity probes are enabled/disabled and calibrated using the same menus

and procedures as the Apex Base Module probes, see the section titled Probe

Setup for more information.

PROBE MODULE 3

AquaController Apex Probe Module 3 (PM3) adds a Temperature and Dissolved

Oxygen ports to the Apex system. This module connects anywhere on the

AquaBus and includes 2 AquaBus ports for flexible connection options. PM3 also

includes 6 digital inputs for connecting float switches, sensors, etc. PM3

temperature and Dissolved Oxygen probes are enabled/disabled and calibrated

using the same menus and procedures as the Apex Base Module probes, see the

section titled Probe Setup for more information.

UPDATING AQUABUS MODULES

See the section titled Updating Firmware for instructions on updating AquaBus

modules.

DELETE AN APEX MODULE

To delete an Apex Module from the system:

Apex Display: Setup – Module Setup – Delete Module – use the up/down

arrows to highlight the Apex module to delete, push Select to delete.

Web Interface: Configuration – Module Setup – in the Module: box in the

Module Configure area, select the Apex module to delete from the

dropdown list, click the Delete Module radio button, click the Submit

Module Update button.

RENAME AN APEX MODULE

To rename an Apex Module from the system:

Apex Display: Setup – Module Setup – Modify Name – use the up/down

arrows to highlight the Apex module to rename, push Select, use the

up/down arrows to change the highlighted digit, use the left/right arrows to

select the highlighted digit, when done, press OK.

Web Interface: Configuration – Module Setup – in the Module Configure

area, in the Module: box, select the Apex module to rename from the

Brand	Neptune Systems
Model	AquaController Apex Classic
Category	Control Unit
Language	English

Neptune Systems AquaController Apex Classic User Manual

Questions and Answers: