Apex Classic Setup and Programming Guide v2.2 Page 66
Setup – Profile Setup – Edit Settings – use the up/down arrows to highlight
the Profile you wish to edit, press Select.
Highlight the parameter you wish to change and push Select, use the up/down
arrow keys to change the value, press Select when done.
Push Save to save or Exit to discard changes.
Editing Profiles from the Web Interface:
Configuration – Profile Setup – in the Profile: box, select the Profile you
wish to edit from the drop down box, type the Profile name in the Name:
box, select the Profile type from the Control Type drop down box, enter the
parameters for the Profile, click the Update Profile when done.
PROGRAMMING WITH PROFILES
The AquaController Apex has 4 variable speed ports. By default, they are named
VarSpd1_I1 through VarSpd4_I4. Variable speed ports are programmed using
the Advanced Programming mode, see the section titled Advanced Programming
for more information on editing outlet programs in Advanced Mode.
Once the Profiles have been defined, use the command below to assign the active
Profile to a variable speed outlet:
Set PF1
Replace PF1 with the name of the Profile you wish to use on the outlet. This will
run the variable speed port with Profile PF1.
Profiles can also be set with conditional commands like:
If Outlet Light1 = ON Then PF2
If Time 2:00 to 2:10 Then PF4
If FeedA Then PF6
You can also turn off variable speed ports using standard OFF commands like:
IF Outlet Light1 = OFF Then OFF
If FeedB Then OFF
NOTE: When the variable stopped port is set off using a command like these, the
port will be completely off (it will not use the Minimum speed setting of any
Profile).
To Next Page
Loading...
Need help?
General