Apex Classic Setup and Programming Guide v2.2 Page 46
PROGRAMMING OUTLETS
DEFAULT PROGRAM
To make getting started with the AquaController Apex easy, outlets on installed
outlet modules are setup with default assignments and programs that can be
used as-is, modified to suit your specific needs or erased and reprogrammed to
whatever you need. The default assignment and program for the 8 outlets on an
EnergyBar 8 is listed below:
Outlet 1: Light1 – suitable for actinic lighting
Outlet 2: Light2 – suitable for daytime lighting
Outlet 3: Pump1 – oscillate on and off with Pump 2
Outlet 4: Pump2 – oscillate on and off with Pump 1
Outlet 5: Heater – on at 77 and off at 78 degrees
Outlet 6: Chiller – on at 79 and off at 78 degrees
Outlet 7: CO2 – CO2 on at 8.00 and off at 7.90
Outlet 8: Ozone – Ozone on at 360 and off at 375
To edit the default program, see the instructions in the section titled Editing
Outlet Programming for instructions.
PROGRAMMING WITH WIZARDS
The AquaController Apex includes several programming Wizards to program
common outlet functions. These allow you to easily program an outlet without
learning the Apex programming language and process. The Apex includes 6
Wizards as described below. To program an outlet using one of these Wizards,
see the section titled Editing Outlet Programming for instructions.
NOTE: See the section titled Programming with Hysteresis for information on
selecting proper set points to prevent outlets from cycling on and off too
frequently.
LIGHT
This Wizard is used to program lights and includes a safety feature that will turn
off lighting if the temperature of the tank gets too high.
Fallback – the state the outlet should switch to if contact between the
EnergyBar and base module is lost (on or off).
On time – the time the light should turn on in 24 hour format
(hours:minutes).
To Next Page
Loading...
Need help?
General